(Profile is work in progress - March 2026)
The following settings have been optimized for the BambuLab P2S. These settings are based on HoHansen, Timnolte, Painted4Combat and ObscuraNoc settings and tweaks. At this point - Thank you for your work. Disclaimer: Please always check before printing if the settings are applicable for your setup, printer and environment.
Requirements for these settings
- The nozzle is a stainless steel 0.2mm
- The filament is SUNLU PLA+ 2.0.
- OrcaSlicer in the newest version (this guide is written based on 2.3.2-rc)
- Textured PEI Plate. Another will work as well but you will need to tweak your brim settings, temperature and cooling.
Settings
Start with a standard profile of the P2S and set it to 0.2mm nozzle, the according build plate and the filament type. Then set your base process settings to 0.08mm layer height and start from there. The settings are split into the following sections:
- Printer
- Filament
- Process
Every setting is listed as a screenshot taken from OrcaSlicer.
Printer
Filament
Process
Quality Settings
Strength
Speed
Support
Multimaterial
Others
