Timnolte supports v5

These settings assume that you are using Orcaslicer, which is the recommended slicer for printing miniatures. However since many slicers are forks of one another, you will likely be able to find the same or similar settings in the slicer of your choice.

Support

Setting Name	Setting Value	Setting Type	Notes
Enable Support	yes	checkbox
Type	Tree (auto)	dropdown
Style	Organic	dropdown
Threshold Angle	25	direct entry
Threshold Overlap	50%	mm or %
First Layer Density	90%	direct entry
First Layer Expansion	6	mm	determines how big of a “brim” each support will have. Can be adjusted based on your printbed adhesion.
On Build Plate Only	yes	checkbox
Remove Small Overhangs	yes	checkbox

Raft

Setting Name	Setting Value	Setting Type	Notes
Raft Layers	0	direct entry	Set this to a value greater than 0 to enable raft

Filament for Supports

Setting Name	Setting Value	Setting Type	Notes
Support/Raft Base	Default	dropdown
Support/Raft Inteface	Default	dropdown

Advanced

Setting Name	Setting Value	Setting Type	Notes
Top Z Distance	0.2	mm
Bottom Z Distance	0.2	mm
Support Wall Loops	2	direct entry
Base Pattern	Hollow	dropdown
Base Pattern Spacing	2.5	mm
Pattern Angle	0	direct entry (degrees)
Top Interface Layers	3	dropdown / direct entry
Bottom Interface Layers	2	dropdown / direct entry
Interface Pattern	Concentric	dropdown
Top Interface Spacing	0.25	mm
Bottom Interface Spacing	0.5	mm
Normal Support Expansion	0	mm
Support/Object XY Distance	0.25	mm
Support/Object First Layer Gap	0.2	mm
Don’t Support Bridges	No	checkbox
Independent Support Layer Height	Yes	checkbox

Tree Supports

Setting Name	Setting Value	Setting Type	Notes
Tip Diameter	1	mm
Tree Support Branch Distance	1	mm
Branch Density	25	%
Tree Support Branch Diameter	1	mm
Branch Diameter Angle	2	degrees
Tree Support Branch Angle	40	degrees
Preferred Branch Angle	45	degrees