TimNolte: Created page with "=== Timnolte CC1 OrcaSlicer Profile === This profile uses the v8(beta) supports settings. These settings require a highly calibrated filament profile that supports good overhangs at a 70 degree or better overhang. * 0.2mm nozzle * 0.06mm layer height * Organic Tree Support (some keys to note) Raft: (This is generally turned off when used but sometime a model may need it ssuccessfully print.) * 2 Layers * 0mm Contact Distance Support Walls: 1 (required if using..."

2026-06-08T01:55:51Z

Created page with "=== Timnolte CC1 OrcaSlicer Profile === This profile uses the v8(beta) supports settings. These settings require a highly calibrated filament profile that supports good overhangs at a 70 degree or better overhang. * 0.2mm nozzle * 0.06mm layer height * Organic Tree Support (some keys to note) ** Raft: (This is generally turned off when used but sometime a model may need it ssuccessfully print.) *** 2 Layers *** 0mm Contact Distance ** Support Walls: 1 (required if using..."

New page

=== Timnolte CC1 OrcaSlicer Profile ===
This profile uses the v8(beta) supports settings. These settings require a highly calibrated filament profile that supports good overhangs at a 70 degree or better overhang.

* 0.2mm nozzle
* 0.06mm layer height
* Organic Tree Support (some keys to note)
** Raft: (This is generally turned off when used but sometime a model may need it ssuccessfully print.)
*** 2 Layers
*** 0mm Contact Distance
** Support Walls: 1 (required if using a support infill)
** Base Pattern Spacing: 0.1mm (This is the amount of infill. This setting makes them more or less dense. My setting makes them more dense for strength.)

File: https://drive.google.com/file/d/1E1KBjKjxWirFXMaw81OrikvumZ0J531T/view?usp=drive_link

Elegoo Centauri Carbon - Revision history